[HamWAN PSDR] 44.x.x.x HamWAN network at Paine

Dean Gibson AE7Q hamwan at ae7q.com
Sun Apr 27 18:48:34 PDT 2014


I had to Google to find out what P2MP was, but in my VERY brief Google 
education on the subject, I don't think it applies.

The radio doesn't multiplex anything.

The consumer-grade routers I own (Linksys BEFSR41, Netgear WGT624v2) 
seem to have no way to turn off NAT.  dd-wrt is not possible with the 
BEFSR41;  it is "work-in-progress" for the WGT624v2.  NAT seems to make 
routing issues a little more complex to think through.  Both routers 
have the ability to specify a "DMZ host", but I think that just turns on 
universal NAT to that host.  Both routers have the capability of 
manually adding entries to a static routing table, but I don't know if 
that skips over the NAT.  If we have to have NAT, it seems to me that 
the best way to set up the router is with the radio connected to the LAN 
side (with whatever private IP address we want), and have the WAN side 
connected to the 44.x.x.x network. That allows incoming (ie, via the 
radio)  packets to go wherever they can and responses to come back; 
whereas orienting the router the other way (unless we use the "DMZ host" 
feature) doesn't.  I suppose I could donate one of my (very) elderly 
(2005) Dell PowerEdge 1650 1U servers to the effort, but that seems like 
a bit of overkill ...

What I think would be a good idea is to meet and discuss this 
face-to-face (pretty much anytime) with diagrams, rather than shoveling 
eMails back and forth.  Scott, if your schedule permits, you are more 
than welcome.

-- Dean

ps: Scott, I plan to come to the DEM on Tuesday to start on this, unless 
you're not going to be there, or other conditions (like ongoing slide 
work) make it a bad idea.

On 2014-04-27 12:06, Bart Kus wrote:
> OK, we can slap some extra security on there.  Shouldn't need an extra 
> router for that.
>
> What about the PtMP story?  One of the advantages you mentioned (Dean) 
> was mobile access.  Can it multiplex access somehow?
>
> --Bart
>
>
> On 4/27/2014 9:53 AM, Dean Gibson AE7Q wrote:
>> Exactly (or the equivalent).
>>
>> On 2014-04-27 09:34, John Hays wrote:
>>> It should be on a dedicated router on its own segment.
>>>
>>> Sent from my iPhone
>>>
>>> On Apr 27, 2014, at 9:27 AM, Dean Gibson AE7Q <hamwan at ae7q.com 
>>> <mailto:hamwan at ae7q.com>> wrote:
>>>
>>>> The only "authentication" the radio has, are the following:
>>>>
>>>>  1. The radio can be set to only receive remote transmissions that
>>>>     include a two-digit decimal code; *or*
>>>>  2. The radio can be set to only receive remote transmissions that
>>>>     are addressed to the callsign programmed into the receiving
>>>>     radio (I would recommend this setting).
>>>>
>>>> Any other authentication would have to be provided by a router or 
>>>> firewall.
>>>>
>>>> On 2014-04-26 22:39, Bart Kus wrote:
>>>>> Any packets on that LAN are considered trusted since they passed 
>>>>> authentication.  What's the auth story on the 23cm modems?
>>>>>
>>>>> --Bart
>>>>>
>>>>> On 4/26/2014 10:37 PM, Tom Hayward wrote:
>>>>>> On Sat, Apr 26, 2014 at 9:26 PM, Dean Gibson AE7Q 
>>>>>> <hamwan at ae7q.com> wrote:
>>>>>>> At the Snohomish County DEM, place a router (or bridge) between 
>>>>>>> the ID-1 and the 44.24.240.x network.
>>>>>>> In this scenario, the ID-1 located at my house would also be 
>>>>>>> connected to a router that acts as though it were directly 
>>>>>>> connected to the 44.24.240.x (or any other) network at the DEM.
>>>>>> We have a router at Snohomish County DEM with an extra port that 
>>>>>> could be used for this. The subnet there is 44.24.240.128/28. We 
>>>>>> have another subnet of address pairs set aside for 
>>>>>> router-to-router links. So as far as networking goes, we could 
>>>>>> execute your plan. I can't commend about the feasibility of any 
>>>>>> of the other bits.
>>>>>>
>>>>>> Tom 
>>
>>
>> _______________________________________________
>> PSDR mailing list
>> PSDR at hamwan.org
>> http://mail.hamwan.org/mailman/listinfo/psdr_hamwan.org
>
>
>
> _______________________________________________
> PSDR mailing list
> PSDR at hamwan.org
> http://mail.hamwan.org/mailman/listinfo/psdr_hamwan.org

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.hamwan.net/pipermail/psdr/attachments/20140427/4be707c9/attachment.html>


More information about the PSDR mailing list