<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN"><html><head><meta content="text/html;charset=UTF-8" http-equiv="Content-Type"></head><body ><div style="font-family: Verdana, Arial, Helvetica, sans-serif; font-size: 10pt;"><div>Bob,<br></div><div><br></div><div><br></div><div>One out-of-the-blue question: Do you have both chains enabled on the radio? The factory default setting (for the RB912UAG-5HPnD at least) is to just enable chain 0. Last time I checked, the configuration instructions on the HamWAN web site don't enable the second chain (chain 1). Enabling the second chain can make a pretty substantial difference in net signal margin and stability.<br></div><div><br></div><div>Assuming that you are using a MIMO radio, to check this run:<br></div><div><br></div><div>/interface wireless monitor 0 once<br></div><div><br></div><div>You should have these lines in the display:<br></div><div>signal-strength: <br></div><div>signal-strength-ch0: <br></div><div>signal-strength-ch1: <br></div><div>tx-signal-strength: <br></div><div>tx-signal-strength-ch0: <br></div><div>tx-signal-strength-ch1: <br></div><div><br></div><div>If you only have the following, then you are running in single-chain mode:<br></div><div>signal-strength: <br></div><div>signal-strength-ch0: <br></div><div>tx-signal-strength: <br></div><div>tx-signal-strength-ch0: <br></div><div><br></div><div>To enable both chains:<br></div><div><br></div><div>/interface wireless set 0 rx-chains=0,1 tx-chains=0,1<br></div><div><br></div><div>John KX7JM<br></div><br><div data-zbluepencil-ignore="true" id="Zm-_Id_-Sgn"><div><hr>John C. Miller<br></div><div><a href="mailto:john@jmit.com">john@jmit.com</a><br></div><div>(530)873-9005<br></div></div><br><div data-zbluepencil-ignore="true" style="" class="zmail_extra"><br><div id="Zm-_Id_-Sgn1">---- On Sat, 29 Feb 2020 05:51:14 -0800 <b>Bob.k6mby <k6mby@olypen.com></b> wrote ----<br></div><br><blockquote style="border-left: 1px solid rgb(204, 204, 204); padding-left: 6px; margin: 0px 0px 0px 5px;"><div>Thanks Carl. Went in the wireless tab and set country and frequency mode then ran the regular item 21 config line and it went without error. <br><br>Bob<br>K6MBY<br>Sequim, WA<br><br><br>_______________________________________________<br>PSDR mailing list<br><a target="_blank" href="mailto:PSDR@hamwan.org">PSDR@hamwan.org</a><br><a target="_blank" href="http://mail.hamwan.net/mailman/listinfo/psdr">http://mail.hamwan.net/mailman/listinfo/psdr</a><br></div></blockquote></div><div><br></div></div><br></body></html>